Digiplex DGP2-641R Manuel d'installation télécharger pdf (Page 18)

14 Reference & Installation Manual

Option [2] OFF= Beep disabled: Communicator Troubles

Option [2] ON = Beep enabled: Communicator Troubles

Option [3] OFF= Beep disabled: Module and Combus Troubles

Option [3] ON = Beep enabled: Module and Combus Troubles

Option [4] OFF= Beep disabled: all Zone Troubles

Option [4] ON = Beep enabled: all Zone Troubles

4.12 Keypad Tamper Enable

SECTION [006]: OPTION [5]

With tamper enabled and the on-board tamper switch is triggered, a

Tamper report will be sent to the control panel via the combus.

Option [5] OFF= Keypad's tamper is disabled (default)

Option [5] ON = Keypad's tamper is enabled

4.13 Time Format

SECTION [005]: OPTION [7]

This feature determines whether the time shown on the screen will be

displayed using the International time format (24Hr. clock) or the US

time format (AM/PM).

Option [7] OFF= Time uses the International time format (default).

Option [7] ON = Time uses the US time format.

4.14 Combus Voltmeter

The combus voltmeter displays the real-time voltage and verifies if the

combus is supplying sufficient power at the keypad module’s location.

Readings will appear on the LCD screen. A reading of 10.5V indicates

that the voltage is too low. This may occur when too many modules are

connected to the combus, a module is installed too far from the panel or

if the system is running on the battery. In some cases adding an

DGP2641R_ei00.fm Page 14 Thursday, July 22, 2004 4:16 PM

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Pas de commentaire

Digiplex DGP2-641R Manuel d'installation Page 18