Digiplex DGP2-641R Manuel d'installation télécharger pdf (Page 12)

8 Reference & Installation Manual

3.0 PROGRAMMING

Programming the DGP2-641R keypad module is simple. Enter Module

Programming Mode, enter the desired section followed by the required

data. When programming the keypad, use the keypad’s programming

sheets (found in the Digiplex Series Modules’ Programming Guide) to

keep track of which sections were programmed and how. We strongly

recommend you read this entire manual before you begin programming.

This module can also be programmed using the WinLoad Installer

Upload/Download Software. For more information, refer to the WinLoad

instructions or visit our Web site at www.paradox.ca.

3.1 Entering Module Programming Mode

The keypad, like all other modules in the system, is programmed

through the control panel. To do so, you must first enter Module

Programming Mode:

1. From Normal Mode press and hold the [0] key.

2. Enter the [

INSTALLER CODE] (by default 000000).

3. Enter section [953] (DGP-848) / [4003] (DGP-NE96).

4. Enter the keypad’s 8-digit [

SERIAL NUMBER].

5. Enter the 3-digit [

SECTION] you want to program.

6. Enter the required [

DATA].

The control panel will then redirect all programming to the selected

keypad. Every time the [

CLEAR] key is pressed it will revert to the

preceding step, unless entering in data in which case it will erase the

current data entry. Please note that the serial number is located on the

keypad's PC board or enter section [000] in Step 3 to view the keypad’s

serial number.

DGP2641R_ei00.fm Page 8 Thursday, July 22, 2004 4:16 PM

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Pas de commentaire

Digiplex DGP2-641R Manuel d'installation Page 12