Digiplex DGP2-641R Manuel d'installation télécharger pdf (Page 11)

Digiplex LCD Keypad 7n

3.6 Copy the Keypad Contents to the Memory Key

Section [520]

1. Insert the memory key onto the keypad’s connector

labelled “

KEY” (refer to Figure 2.1 on page 3). Ensure that

the write protect jumper is ON (refer to Figure 3.1).

2. To copy the contents to the memory key, enter the

keypad’s programming mode and enter section [520].

3. After the confirmation beep, wait 5 seconds and remove

the memory key after the second confirmation beep. Set

the memory key’s jumper to OFF if you do not wish to

accidentally overwrite its contents (refer to Figure 3.1).

Figure 3.1: PMC-3 Jumper Settings

DGP2641-EI14.fm Page 7 Monday, February 20, 2006 9:35 AM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Pas de commentaire

Digiplex DGP2-641R Manuel d'installation Page 11