Digiplex DGP2-641R Manuel d'installation télécharger pdf (Page 40)

38 Reference & Installation Manual

in the Event Buffer and can be reported to a

Monitoring Station.

Door Left Open: Each Access Control door is programmed with a

period of time it is allowed to remain open. Once

the door has been open past this time limit, an

Access Alarm will be triggered (see Access

Alarm).

Event Buffer: The user-initiated actions, alarms, and troubles

that occur in the system are saved in the control

panel’s memory: the Event Buffer. To view the

events you must enter the Event Record Display

(see Digiplex or DigiplexNE Reference &

Installation Manual). The Access Control events,

however, can only be viewed through an Access

Control Keypad (DGP2-641AC).

Forced Door: If a protected door was opened without an

“Access Granted” or “Request for Exit” signal, a

silent or audible Access Alarm can be triggered.

If the Access Alarm is programmed to be

audible, the reader assigned to the door can

beep. This event is logged in the Event Buffer,

but can only be seen through an Access Control

keypad (DGP2-641AC) and cannot be reported

to a Monitoring Station unless the door is also

assigned to a zone. If the door is assigned to a

zone, the Forced Door can also trigger a Burglar

Alarm in the system.

1 2 ... 35 36 37 38 39 40 41 42 43 44

Pas de commentaire

Digiplex DGP2-641R Manuel d'installation Page 40